promotionjae.blogg.se - Kode e2 pada printer canon mp258

E04, E05, E14 or E15: Cartridge may not be installed properly.Pressing the Stop / Reset button for 5 to 8 seconds until the led screen display number 1. Try to change the scanner unit or change a the logic board. P22 (Scanner error): a scanner malfunction.

P20 (Other hardware error): The failure of other hardware.

If the error still exist replace the logic board.

P15 (USB VBUS over current): caused by too much current, try removing the USB cable and then plugin again, if solve the error, try to replace with a new USB cable.

P09 (EEPROM error): caused by corrupted or defective EEPROM chips of the printer.

Replace the new cartridge print head and / or change a new logic board.

P08 (Print head temperature rise error): caused by thermal print head temperature exceeds a threshold.

Replace the wastepad inside the printer or install waste ink bin outside the printer then reset counter protection.

P07 (Ink absorber full): the Ink Wastepad (sponge) inside the printer is full.

P06 (Internal temperature error): caused by abnormal heat inside the printer.

Try to replace the following: ASF / PE sensor unit, Drive unit, PCB logic board.

P05 (ASF sensor error) sensor for paper feed error.

P03 (Line feed error): an error in transmission line entering the line feed (LF) is a signal telling the printer to move to another line or a whole new line that would not otherwise have reached the end of the line.Check wire print head position (timing slit disk film) on the side of the machine.

P02 (Carriage error): Make sure no foreign material stuck to the print head railway.Ĭlean and check the print head encoder strip cable (timing slit film or encoder strip is a white line on the back of the box set of ink lines may be missing or mess up the ink.

Kode Error Canon MP258 dengan Huruf 'P' dan 'E'